1-805-484-2992
Quotes - Engineering - SalesOverview
This is Advantage's standard water-circulating TCU range, covering the VE, G and Temptender series, with flow rates from 35 to 100 GPM depending on model. Water is pumped through the mold, die or process jacket and back through the unit, which trims heat in or out to hold the setpoint tightly even as the process load changes through a cycle.
Typical duty includes hot-runner injection molds that need the manifold held at a steady elevated temperature, laminating processes, and die-casting die preheat where the die needs to be brought up to and held at temperature before and during production.
Because these are water units, 250°F is close to the practical ceiling for reliable water circulation at normal system pressures - processes that need to run hotter belong on a hot-oil unit instead. Tell us the required setpoint, flow rate and mold or process connection details and we'll match a series.
- 35 to 100 GPM depending on model
- VE, G and Temptender series
- Common on hot-runner injection molds, laminating lines and die preheat
Confirming 250°F Service Is Enough
An Advantage 250°F unit fits most standard hot-runner, laminating and die-preheat duty where the process setpoint sits comfortably below the unit's ceiling. Running a 250°F-rated unit continuously at or near its limit is harder on seals and pump life than choosing a series with real margin, so treat the rated ceiling as a limit to stay away from, not a target to size against.
If your required setpoint is at or above roughly 240°F with little margin, compare this page against Up to 300°F before committing to a model - the extra headroom is often worth the modest cost difference.
Send Us
- Required fluid setpoint
- Required flow rate (GPM)
- Mold, die or process connection details
- Whether the setpoint could increase in future production
Where 250°F Units Work
250°F VS. 300°F SERVICE
| Factor | Up to 250°F (VE, G, Temptender) | Up to 300°F (G300, T300) |
|---|---|---|
| Fluid | Water | Water |
| Flow | 35-100 GPM | 35-100 GPM |
| Typical use | Standard hot-runner molds, laminating, die preheat | Same duty types run at a higher required setpoint |
| When to step up | - | Choose when a 250°F unit would run at or near its ceiling continuously |
Above 300°F, move to a hot-oil unit rather than pushing a water-based system past its design range.
Call and talk it through with an engineer: 1-805-484-2992.
